Eureka Atom Specialty 65 Espresso Coffee Grinder
- Stepless – Gives you an “infinite” range of settings that allow you to really fine-tune your grind to your espresso machine. Turn clockwise for a finer grind and counterclockwise for a coarser grind.
- Perfect positioning – The adjustment knob is located on the top right of the grinder, underneath the bean hopper. This helps keep the overall width of the Eureka Atom Specialty 65 low compared to other grinders that have it on the side. This also protects it from hitting against other equipment.
- Flat grinding burrs – Large size at 65 mm. The larger the size, the more of a grinding surface, resulting in faster production. The burrs are made of long-lasting, hardened steel.
- High rpm – Faster spinning rate at 1650 rpm. The higher the speed, the faster the production, which can increase efficiency and reduce wait times. Espresso grinding is approximately 2.7 – 3.7 grams / second.
- Time-based grinding – The “1-cup” mode can adjust from 0.5 seconds to 25 seconds. The “2-cup” mode can adjust from 0.5 seconds to 35 seconds. You can adjust the time by 0.1-second increments. The semi-automatic mode tracks the time from start to stop.
- Color display – When semi-automatic dosing, the display switches to a picture of a grinding burr with a timer in the center. It will count up by 0.1-second increments until you stop. When electronic dosing, the screen will highlight whether you select “1-cup” or “2-cup”. The timer will count down when you start the grinding cycle.
- Portafilter fork – Used mainly for espresso grinding. The distance from the portafilter fork to the coffee chute is approximately 2.5″. There is a built-in lip that helps hold your portafilter in place. The distance from the portafilter fork to the lip is approximately 1.5″.
- High capacity – The hopper holds approximately 1200 grams of whole coffee beans. Essentially you can dump a whole standard kilo bag of coffee.
- Rubber neck guard – The bean hopper sits comfortably on top of the grinder. There is a rubber neck guard that helps protect the neck of the bean hopper from cracking.
- Set screw – Secures the hopper to the grinder. Prevents users from quickly removing the hopper, spilling beans everywhere.
- Finger guard – Prevents users from “accidentally” putting their fingers in the grinding burrs.
- Stopper – A door near the bottom of the hopper can be pushed in to close the opening. This allows you to remove the hopper with beans inside so you can easily change the beans. There will be some beans already passed in the burrs which will have to be ground out first before removing the hopper.